Chapter 8: Installing the Driver on an Existing Operating System ● 57● For VMware, see page 59.● For FreeBSD, see page 60Installing on WindowsTo install the driver on Windows:1 Start or restart Windows.The Found New Hardware Wizard opens and searches for the driver.2 Insert the driver disk, select Floppy drive, then click Next.3 Click Next, then click Next again.4 Follow the on-screen instructions to complete the driver installation.5 Remove the driver disk and restart your computer.6 Continue with Managing Your Storage Space on page 61.Installing on Red Hat or SUSE LinuxTo install the module on Red Hat or SUSE Linux:1 Insert and mount the RAID Installation CD:Red Hat: mount /dev/cdrom /mnt/cdromSUSE: mount /dev/cdrom /media/cdrom2 Install the module RPM:rpm -Uvh mount-point/xxx/yyy.rpmwhere mount-point is the specific mount point on the Linux system, xxx is the driver path,and yyy.rpm is the rpm file.3 Reboot your computer to ensure the driver loaded correctly.4 Run fdisk, mkfs, and create mount points for any new disk drives.5 Continue with Managing Your Storage Space on page 61.Installing on NetWareNote: Before you begin, ensure that your NetWare operating system has been upgraded to theminimum patch level specified by Novell. Refer to the Novell Web site for more information.To install the driver on NetWare:1 Start your computer.2 At the NetWare server console prompt, type load hdetect, then press Enter if it has not beloaded automatically.3 At the Device types menu, select Continue, then press Enter.4 At the Device type option, select Modify, then press Enter.5 Select Storage Adapters, then press Enter.
