Advanced LIFELINE Px-100 Product Manual

Also see for LIFELINE Px-100: User guide

Advanced LIFELINE Px-100 Product Manual Manual pdf 29 page image

www.advancedco.com 29Use the  buttons to highlight the required power level and then press the ✔ button to select it.Refer to the Site Survey section for the procedure and tools / settings required to undertake the task ofsurveying the site and commissioning the panel for optimal transmitter power / reception.4.2.6 PasswordsThis menu allows the four user passwords and the engineering password to be adjusted.[Select User]USER 1 :1234USER 2 :1234USER 3 :1234USER 4 :1234ENGINEER :7654The menu shows the output settings available.Use the  buttons to highlight the required USER and then press the ✔ button to select it.[Number Entry]Value: 1234Enter New Value:-0Maximum: 99999999The display shows the number entry screen.The password can be from 1 digit up to 8digits in length.Enter the required password using the number buttons and the ✔ button to confirm.4.2.7 General ParametersThis menu allows the four user passwords and the engineering password to be adjusted.[General Settings]LEVEL2 TIME-OUT: 5WALK TEST DELAY: 301 SEND –REPEATS: 0OUT-OF-RANGE: YESESPA ADDRESS: 2The menu shows the general parameter settingsavailable.Use the  buttons to highlight the required parameter and then press the ✔ button to select it.4.2.7.1 Level 2 Time-OutAccess to the controls (Level 2) can be configured to automatically cancel after a preset time of no activity. Thedefault time is 5 minutes.Select the option and use the number buttons to change the time-out. The time-out can be adjusted in the range0 - 5 minutes. Where 0 is configured, the menu will never timeout.4.2.7.2 Walk Test DelayThe walk test function can be adjusted to alter the time between each message transmission – default 30seconds.Select the option and use the number buttons to change the delay. The delay can be adjusted in the range 5 -60 seconds.4.2.7.3 1 Send RepeatsThe ‘1 Send Repeats’ parameter determines the number of repeated sends of the same message which followa transmission resulting from an input trigger configured as Transmit –Once.Select the option and use the number buttons to change the setting. The number of repeat sends can beadjusted in the range 0 - 10 seconds.