Axis 0942-001 User Manual

AXIS Q6055-C PTZ Network CameraHow to access the productClick the Emulate joystick mode button and click in the image to move the camera view in the direction of themouse pointer.Click the Center mode button and click in the image to center the camera view on that position.The center mode button could also be used to zoom in on a specific area. Click in the image and drag to draw arectangle surrounding the area to be magnified. To zoom out, rotate the mouse wheel.Click the Ctrl panel button to open the PTZ control panel which provides additional PTZ controls.User-defined buttons can also appear in the Control panel. See About advanced PTZ settingson page 32.Select a recorded tour and click to play a previously recorded tour and click to stop.See About tour recording on page 31.Select a PTZ preset position to steer the camera view to the saved position. See About presetpositions on page 28.Click the Start Auto Track button to start autotracking directly from the live view window. SeeAutotracking on page 29.Pan and Tilt bars – Use the arrows to pan and tilt the camera view, or click on a position on the bar to steer the camera view tothat position.Zoom bar – Use the arrows to zoom in and out, or click on a position on the bar to zoom to that position.Focus bar – Use the arrows to focus the camera, or click on a position on the bar to set the focus position. Using the focus bar willdisable the product’s autofocus. To re-enable, use the PTZ control panel which is opened by clicking the Ctrl panel button (see above).Iris bar – Click on a position to set a manual exposure level to make the image brighter or darker. This will disable auto iris (automaticexposure) and set fixed levels on iris, gain and shutter speed. To re-enable auto iris, use the PTZ control panel which is opened byclicking the Ctrl panel button (see above). If auto iris is enabled, Auto is visible next to the Iris bar bar.ImportantIn an environment with varying light conditions it is recommended to use the Brightness bar instead of the Iris bar to adjustimage brightness since changing the brightness level will not disable auto iris (automatic exposure).Brightness bar – Click on a position on the brightness bar to adjust the image brightness. This setting will not be saved. To make asaved change, go to Setup > Video > Camera Settings > Brightness and adjust the brightness.The PTZ controls can be disabled under PTZ > Advanced > Controls, see About advanced PTZ settings on page 32.14