Page 4 AXIS 1650 Set-up InstructionsConnect AXIS 16501. Make sure the Canon device is off and unplugged and that the AXIS 1650 externalpower supply is disconnected.2. Locate the serial number, found on the underside label of the AXIS 1650, and write itdown. You will need this number to configure the AXIS 1650.3. Connect the AXIS 1650 to the Canon device. Please refer to the correct connection procedure below foryour Canon device.Note: For Canon devices supporting both parallel and USB connections, select one of theconnection procedures below to connect the AXIS 1650.Connect the AXIS 1650 to the USB port using the USB cable.Product NameSerial Number/MAC AddressPrint Server NameFor CANON Devices with USB Port

contenuto della confezione

Axis 1650 Setup Instructions

1650

Section 1 Safety Notices

Section 3 Preface

Section 4 Product Overview

Section 5 Print Server Installation

Set the IP Address

Set an IP Address with NetSpot Device Installer software

IP Address Host Names

Section 6 Windows Installation

Windows 98 and Me

Print Server Installation using the Standard TCP/IP Port in Windows 2000/XP/2003

Section 7 Adding Printers in NetWare

Setup using NetWare 6.0

Section 8 Print Server Management and Configuration

Accessing the Web

Services Available from the User Mode

Services Available from the Admin Mode

Setting General Parameters

Setting Restrictions

Setting Network Protocol Parameters

Print Server Management Using FTP

Print Server Management Using SNMP

Section 9 Scanning with AXIS 1650

Using AXIS ScanClient

Invoking a Scan from the Canon Device

Section 10 The Test Button

Section 11 Upgrading the Firmware

Section 12 Enabling Unicast Network Communication

Section 13 Internet Connection Firewall in Windows XP SP2

Section 14 Technical Specifications

Index

safety notices

patent information

About this Manual

Support Services

Section 1 Product Overview

Section 2 Print Server Installation

Section 3 Windows Installation

Using AXIS CAPT Print Monitor in Windows 2000, XP and Server 2003

Using AXIS CAPT Print Monitor in Windows 98 and Me

Using the Standard TCP/IP Port in Windows 2000/XP/2003

Section 4 Print Server Management and Configuration

Print Server Management from the Embedded Web

Accessing the Embedded Web

Available Services from the User Mode

Available Services from the Admin Mode

network settings

Section 5 The Test Button

Section 6 Upgrading the Firmware

technical specifications