Axis 7100 User Manual
Also see for 7100: User manual
                               | |
Contents
| 
AXIS 7100 User’s Guide Basic Installation 11Connecting the WORKiO CopierCaution!1. Switch off the WORKiO copier and disconnect the AXIS 7100 external powersupply.2. Connect AXIS 7100 to the WORKiO copier using a fully connected parallel cable.Connecting the AXIS 7100 to the network1. Connect your AXIS 7100 to the network. The AXIS 7100 is designed for 10 MbpsEthernet and 100 Mbps Fast Ethernet networks and connects to the network viaa twisted pair category 5 cable (10baseT and 100baseTX).2. Switch on the WORKiO copier.3. Connect the external power supply to the AXIS 7100. The network indicator willflash during power up and self test. The following message will appear on thedisplay during self test (stating the software version number, e.g. 1.00):Note:• Check that the power supply included with your AXIS 7100 is marked with the correct voltage.• Make sure that the external power supply to the AXIS 7100 is disconnected before connectingand disconnecting to other units.The tri-colored Network indicator flashes:• yellow - indicating network activity on a 10MB Ethernet network.• green - indicating network activity on a 100MB Fast Ethernet network.• red -indicating that the unit is not correctly connected to the network. |
Related manuals for Axis 7100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine