|
AXIS COMMUNICATIONS Quick User’s GuideAXIS 7100 User’s Guide2About This DocumentThis guide applies to the AXIS 7100 Network Document Serverwith software release 1.00 and subsequent releases untilotherwise notified.The document provides introductory information as well asinstructions on how to set up and manage the AXIS 7100. It isintended for anyone involved in installing and using the AXIS7100.For more detailed instructions, refer to the AXIS 7100 forWORKiO User’s Manual that is available in pdf format at theAxis Website and on the AXIS Product CD.Safety NoticesTake some time to read through the safety notices beforeinstalling the AXIS 7100. Please observe all safety markings andinstructions when using this product.Caution! - must be observed to avoid loss of data or damageto your equipment.Important: - must be observed to avoid operationalimpairment.Do not proceed beyond any of the above notices, until you havefully understood the implications.Copyright InformationThe unauthorized copying of materials that are covered bycopyright and other international proprietary or intellectualproperty rights is prohibited in most countries. AxisCommunications AB recommends that the users of thisequipment seek the necessary authorizations for copyingmaterial. The instructions for use in the manual shall not beconsidered as an inducement to make illicit duplications ofmaterial. Any duplication will be made at the user’s own risk.Electromagnetic Compatibility (EMC)USA - This equipment generates, uses, and can radiate radiofrequency energy and if not installed and used in accordancewith the instruction manual, may cause interference to radiocommunications. It has been tested and found to comply withthe limits for a Class A computing device pursuant to Subpart Bof Part 15 of FCC rules, which are designed to providereasonable protection against such interference when operatedin a commercial environment. Operation of this equipment in aresidential area is likely to cause interference in which case theuser at his/her own expense will be required to take whatevermeasures may be required to correct the interference. Shieldedcables should be used with this unit to ensure compliance withthe Class A limits.Europe - This digital equipment fulfils the requirements forradiated emission according to limit B of EN55022, and therequirements for immunity according to EN55024 residential,commercial, and light industry (Compliance is not valid forunshielded network cables).Japan - This is a class B product based on the standard of theVoluntary Control Council for Interference from InformationTechnology Equipment (VCCI). If this is used near a radio ortelevision receiver in a domestic environment, it may cause radiointerference. Install and use the equipment according to theinstruction manualAustralia - This electronic device meets the requirements of theRadio communications (Electromagnetic Compatibility) Standard1998 AS/NZS 3548.LiabilityEvery care has been taken in the preparation of this manual; if youdetect any inaccuracies or omissions, please inform your local Axisoffice which can be found on the cover of this document. AxisCommunications AB cannot be held responsible for any technical ortypographical errors and reserves the right to make changes to theproduct and manuals without prior notice. Axis Communications ABmakes no warranty of any kind with regard to the materialcontained within this document, including, but not limited to, theimplied warranties of merchantability and fitness for a particularpurpose. Axis Communications AB shall not be liable nor responsiblefor incidental or consequential damages in connection with thefurnishing, performance or use of this material.Trademark AcknowledgmentsAcrobat, Adobe, AIX, DOS, Ethernet, IBM, Internet Explorer,Macintosh, Microsoft, Netscape Navigator, UNIX, Windows andWORKiO are registered trademarks of the respective holders.Software Trademark AcknowledgmentsJPEG code (libjpeg) used courtesy of the Independent JPEG Group.LDAP code (libldap and libber) used courtesy of the University ofMichigan at Ann Arbor. Copyright © 1991 Regents of the Universityof Michigan. All rights reserved. TIFF code (libtiff) used courtesy ofSam Leffler and Silicon Graphics, Inc. Copyright © 1988-1996 SamLeffler. Copyright © 1991-1996 Silicon Graphics, Inc.MaintenanceIt is recommended that you use a moist cloth to clean the unit. Donot use petroleum based substances as this may cause damage.Support ServicesShould you require any technical assistance, please contact yourlocal dealer or local Panasonic office. If your questions cannot beanswered immediately, your dealer will forward your queriesthrough the appropriate channels to ensure you a rapid response.AXIS 7100 for WORKiO User’s Guide Rev: 1.0Part No: 18907 Date: November 2001Copyright © Axis Communications AB 2001
|
