Axis M3006–V User Manual

Also see for M3006-V: User manual Technical specifications Installation guide User manual

AXIS M3006–V Network CameraHardware OverviewNOTICEThe product shall be connected using a shielded network cable (STP). All cables connecting the product to the network switchshall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. SeeElectromagnetic Compatibility (EMC) for regulatory requirements.SD card slot - A standard or high-capacity microSD card (not included) can be used for local recording with removable storage.NOTICETo prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > SystemOptions > Storage > SD Card and click Unmount.Control button - The control button is used for:• Connecting to an AXIS Video Hosting System service. Seepage 37. To connect, press and hold the button for about1 second until the Status LED flashes green.• Connecting to AXIS Internet Dynamic DNS Service. Seepage 37. To connect, press and hold the button forabout 3 seconds.• Resetting the product to factory default settings. Seepage 44.LED IndicatorsColor IndicationUnlit Connection and normal operationAmber Steady during startup. Flashes during firmware upgrade.Amber/red Flashes amber/red if network connection is unavailable or lost.Red Flashes red for firmware upgrade failure.Green Shows steady green for 10 seconds for normal operation after restart.Note• The Status LED can be configured to flash while an event is active.• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .5