Axis M3014 User Manual

Also see for M3014: Datasheet Datasheet Datasheet Installation guide Installation guide

AXIS M3014 Network CameraHardware overviewConnectorsNetwork connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).CautionDue to local regulations or the environmental and electrical conditions in which the product is to be used, a shieldednetwork cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similarshall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. SeeElectromagnetic Compatibility (EMC) for regulatory requirements.Control button - The control button is used for:• Connecting to an AXIS Video Hosting System service. See page 34. To connect, press and hold the button for about1 second until the Status LED flashes green.• Connecting to AXIS Internet Dynamic DNS Service. See page 35. To connect, press and hold the button forabout 3 seconds.• Resetting the product to factory default settings. See page 40.LED indicatorsLED Color IndicationGreen Steady for connection to a 100 MBit/s network. Flashes for network activity.Amber Steady for connection to a 10 MBit/s network. Flashes for network activity.NetworkUnlit No network connection.Green Steady green for normal operation.Amber Steady during startup and when restoring settings.StatusRed Slow flash for failed upgrade.Green Normal operation.PowerAmber Flashes green/amber during firmware upgrade.Note• The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options >LED.See the online help for more information.• The Status LED can be configured to flash while an event is active.• The Status LED can be configured to flash for identifying the unit. This can be done under Setup > System Options >Maintenance.5