Axis M3014 User Manual

Also see for M3014: Datasheet Datasheet Datasheet Installation guide Installation guide

AXIS M3014 Network CameraAccessing the productSet Power Line FrequencyPower line frequency is set the first time the Axis product is accessed and can only be changed from Plain Config or by resetting theproduct to factory default.Select the power line frequency (50 Hz or 60 Hz) used at the location of the Axis product. Selecting the wrong frequency may causeimage flicker if the product is used in fluorescent light environments.When using 50 Hz, the maximum frame rate is limited to 25 fps.NotePower line frequency is different in different geographic regions. In the Americas, 60 Hz is usually used; most other parts ofthe world use 50 Hz. Local variations may apply, always check with the local authorities.The Live View pageIf the Axis product has been customized to meet specific requirements, not all the items described below will appear in the Live Viewpage. The following provides an overview of each available button.Controls on the Live View pageClick View size to scale the image down to 800 pixels wide or to full scale. Only available in MJPEG.The Stream Profile drop-down list allows you to select a customized or pre-programmed stream profile. Streamprofiles are configured under Video > Stream Profiles. See Stream Profiles, on page 15.The Manual Trigger button can trigger an event directly from the Live View page. The button is configured underLive View Config > Action Buttons.Click Snapshot to save a snapshot of the video image. Right-click the video image to save it in JPEG format on yourcomputer. This button is primarily intended for use when the AXIS Media Control viewer toolbar is not available.Enable this button from Live View Config > Action Buttons.8