Axis M5075-G User Manual

Also see for M5075-G: Installation guide User manual

AXIS M5075-G PTZ CameraLearn moreNoteThe product supports COMMAND_CLASS_INDICATOR_V3, however there is no visible indicator.Turn on Z-Wave1. Go to Settings > System > Z-Wave.2. Go to Gateway settings wireless I/O and turn on Z-Wave. You may need to wait for a few minutes for Z-Wave tobecome active.Add a Z-Wave deviceThough not limited by the Z-Wave Plus v2 protocol, your product’s event system allows you to add Z-Wave devices at any given time.If the maximum number is reached, you need to remove a Z-Wave device before you can add a new one. See the product’s datasheetfor information about maximum number of Z-Wave devices.1. Go to Settings > System > Z-Wave.2. Go to Device management and click . The product starts looking for Z-Wave devices in the Z-Wave network.3. Set the Z-Wave device to be added into inclusion/exclusion mode as described in its User Manual.4. If requested, enter the PIN delivered with the Z-Wave device, and click OK.5. Wait until the adding process is finalized as indicated by a notification on the web page.The added Z-Wave device is now visible in the device management list.NoteIf the Z-Wave device is not found, the adding process is terminated automatically.To see the detailed status information of the added Z-Wave device, expand the device information in the device management list.NoteStatus information for an added Z-Wave device varies depending on the device type. For more information, see the onlinehelp .You can set the product to trigger rules with specified Z-Wave trigger conditions. The available Z-Wave conditions and actions varydepending on the added Z-Wave device type.Add a Z-Wave device with SmartStart inclusionYou can add a Z-Wave device to the Z-Wave network with SmartStart inclusion. A Z-Wave device added to the SmartStart list isautomatically added to the device management list within 10 minutes of being powered on in the network vicinity.1. Go to Settings > System > Z-Wave.2. Go to SmartStart and click .3. Type the device specific key and any optional information.4. Click OK.Remove a Z-Wave device through inclusion/exclusion modeNoteThis is the recommended removal procedure.21