Axis M7011 User Manual

Also see for M7011: Installation guide User manual

AXIS M7011 Video EncoderSystem OptionsStorageSD CardNONONOTICETICETICETo prevent data corruption, the SD card should be unmounted before removal.NoteFor SD card recommendations see www.axis.comThe Axis product supports microSD/microSDHC/microSDXC cards.The following SD card file systems are supported:• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To accessdata stored on the card from the Windows operating system, a third-party ext4 driver or application is required.• vFAT — supported by most operating systems for personal computers.The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair. This option is onlyavailable for SD cards with ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.To avoid filling the card, it is recommended to remove recordings continuously. Under General Settings, select Remove recordingsolder than and select the number of days or weeks.To stop writing to the card and protect recordings from being removed, select Lock under General Settings.Mount and Unmount SD CardNONONOTICETICETICETo prevent corruption of recordings, the SD card should always be unmounted before it is ejected.The SD card is automatically mounted when the card is inserted into the Axis product or when the product is started. A manualmount is only required if the card has been unmounted and not ejected and re-inserted.To unmount the SD card:1. Open the Axis product’s webpages and go to Setup > System Options > Storage.2. Click SD Card.3. Click Unmount.4. The card can now be removed.Format SD CardNONONOTICETICETICEFormatting the SD card will remove all data and recordings stored on the card.The Axis product can be configured to automatically format SD cards that are inserted into the product. If autoformat is enabled andan SD card is inserted, the product will check if the SD card has the ext4 file system. If the card has a different file system, thecard will automatically be formatted to ext4.ImportantIf autoformat is enabled, only use new or empty SD cards. Any data stored on the card will be lost when the card is insertedinto the Axis product.49