Axis M7014 User Manual

Also see for M7014: Installation guide Installation guide

Contents

AXIS M7014System OptionsRTSPThe RTSP server running in the Axis product allows a connecting client to start an H.264 stream. The RTSP port number can bechanged under System Options > Network > TCP/IP > Advanced. The default port is 554.NoteH.264 video streams will not be available if the RTSP server is disabled.SOCKSSOCKS is a networking proxy protocol. The Axis product can be configured to use a SOCKS server to reach networks on the otherside of a firewall or proxy server. This functionality is useful if the Axis product is located on a local network behind a firewall, andnotifications, uploads, alarms, etc need to be send to a destination outside the local network (for example the Internet).SOCKS is configured under System Options > Network > SOCKS. For more information, see the online help .QoS (Quality of Service)QoS (Quality of Service) guarantees a certain level of a specified resource to selected traffic on a network. A QoS-aware networkprioritizes network traffic and provides a greater network reliability by controlling the amount of bandwidth an application may use.The QoS settings are configured under System Options > Network > QoS. Using DSCP (Differentiated Services Codepoint) values, theAxis product can mark the following types of traffic: live video, event/alarm traffic and management traffic.SMTP (email)To send email messages from the Axis product via SMTP (Simple Mail Transfer Protocol), an SMTP mail server must be set up. Thisis done under System Options > Network > SMTP (email).Enter the host names or IP addresses and port numbers for the primary and secondary mail servers in the fields provided. A Fromemail address is also required. If the mail server requires authentication, check Use authentication to log in to this server and enterthe necessary information.SNMPThe Simple Network Management Protocol (SNMP) allows remote management of network devices. An SNMP community is thegroup of devices and management station running SNMP. Community names are used to identify groups.The Axis product can be configured to support SNMP on the System Options > Network > SNMP page.Depending on the level of security required, select the version on SNMP to use.SNMP v1/v2 provides the lowest level of security. The community name can be specified as a password for read or read/writeaccess to all supported SNMP devices. The default password for the Read community is public and the default password for theWrite community is write.NoteIf HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.Traps for SNMP v1/v2 are used by the Axis product to send messages to a management system on important events and statuschanges. Check Enable traps and enter the IP address where the trap message should be sent and the Trap community thatshould receive the message.The following traps are available:• Cold start• Warm start• Link up33