Axis P5522 Installation Manual

Also see for DROP CEILING P5522-E: Installation guide User manual Datasheet User manual Preventive Maintenance Instructions and Checklist

Contents

AXIS P5522-E Installation Guide Page 19ENGLISHResetting to the Factory Default SettingsTo reset the camera to the original factory default settings, use the control button and the restartbutton on the side of the camera, see Hardware overview, on page 6, as described below.Using the control and restart buttons will reset all the parameters, including the IP address, to thefactory default settings:1. Remove the sunshield, see illustration on page 6.2. Remove the top cover, see Remove the protective packaging, on page 7.3. Press and hold the control button and the restart button at the same time.4. Release the restart button but continue to hold down the control button.5. Continue to hold down the control button until the status indicator flashes amber at regularintervals (this may take up to 15 seconds).6. Release the control button.7. When the status indicator changes to green (which may take up to 1 minute), the process iscomplete and the camera has been reset. The unit now has the default IP address 192.168.0.908. Put the top cover back in its original position.9. Put the sunshield back in its original position.10. Re-assign the IP address, using one of the methods described in Assign an IP address, on page11.It is also possible to reset parameters to the original factory default settings via the web interface.For more information, please see the online help or the User’s Manual available from the AXISNetwork Video Product CD supplied with this product.Accessing the camera from the InternetOnce installed, your network camera is accessible on your local network (LAN). To access thecamera from the Internet, network routers must be configured to allow incoming traffic, which isusually done on a specific port.• HTTP port (default port 80) for viewing and configuration• RTSP port (default port 554) for viewing H.264 video streamsPlease refer to the documentation for your router for further instructions. For more information onthis and other topics, visit the Axis Support Web at www.axis.com/techsupFurther informationThe User’s Manual is available from the Axis Web site at www.axis.com or from the Axis NetworkVideo Product CD supplied with this product.Tip!Visit www.axis.com/techsup to check if there is updated firmware available for yournetwork camera. To see the currently installed firmware version, see Setup > About.