13ELECTRONIC COMPONENTSCUSTOMER MANUAL FRONT HUB MOTOR SYSTEMChargerThe charger is specially designed for charginglithium-ion batteries. It is equipped with an inte-grated fuse and protection against overcharging.Keep the charger away from children andanimals. Small children and animals maydamage the cable while playing. This can leadto an electric shock, a malfunction or a fire.• The charger must not be used by children, orby persons with limited physical, sensory ormental capabilities, unless under the supervi-sion of a responsible adult.• Make sure the charger is clean. There is arisk of electric shock.• do not use your charger in humid or dustyplaces.• Avoid direct sunlight.• disconnect the charger from the power sup-ply when not in use.• Only use the charger that came with yourpedelec or one from the same manufacturer.• don’t cover the charger while it is in use. Itcould otherwise short circuit or cause a fire.• When you clean the charger, unplug it fromthe electrical socket first.• When charging takes longer than shown inthe specifications table, stop charging.• After charging, remove the battery from thecharger and unplug the charger.4.5 Hub motorYour Pedelec is equipped with a 250 Wattfront-wheel electric motor, which also forms thehub of the front wheel.Motor / Product Model: FM G320.250.VKeep in mind that the motor of your Pedeleccan heat up during long uphill runs. do nottouch the motor, as you may get burnt.The drive is activated as soon as you push downon the pedal. The degree of support dependson the settings on the control unit. As soon asyou stop pedaling while driving, or when youhave reached the maximum speed, the drive willbe disabled. The support is automaticallyreactivated as soon as the speed is below themaximum support speed and you reapplypressure to the pedal.Note that if the road surface is slippery (e.g. dueto rain, snow, sand), there is a risk that the frontwheel of your Pedelec may spin and slide.