BALAY 3VN300BD Instruction Manual

Also see for 3VN300BD: Instructions

BALAY 3VN300BD Instruction Manual Manual pdf 23 page image

en23Waste-water connection– The required work sequence can befound in the installation instructions. Ifrequired, fit a siphon with an drainageconnection.– Connect the waste-water hose to thedrainage connection of the siphon withthe enclosed parts.Ensure that the drainage hose is notkinked, crushed or twisted and thatthere is no cover plate in the drainageto prevent the waste water from flowingout!Fresh water connection– Connect the fresh-water connection tothe tap according to the installationinstructions with the enclosed parts.Ensure that the fresh-water connectionis not kinked, crushed or twisted.– When replacing the appliance, alwaysuse a new water supply hose.Water pressure:at least 0.05 MPa (0.5 bar), maximum1 MPa (10 bar). At a higher waterpressure: connect pressure-reducing valveahead.Inlet rate:minimum 10 litres/minuteWater temperature:cold water preferred; hot water max.temperature 60 °C.Electrical connection– Connect the appliance only to 230 Vand 50 Hz alternating current viaa correctly installed socket withprotective conductor. See rating platefor required fusing 9*.– The socket must be near the applianceand freely accessible followinginstallation.– The connection may be modified bytechnicians only.– A power cord extension may bepurchased from customer service only.– Use only a residual current operatedcircuit-breaker which featuresthe symbol ‚. Only this extensionguarantees compliance withthe currently valid regulations.Removing the applianceAlso observe the sequence of workstepshere.– Disconnect the appliance from thepower supply.– Turn off the water supply.– Disconnect the waste water and freshwater connections.– Loosen the fastening screws under theworktop.– If fitted, remove the base panel.– Pull out the appliance, carefully pullingthe hose behind.

/ 26

Related manuals for BALAY 3VN300BD