Bacharach Portable Combustion Analyzer Instruction

Also see for PCA 20: Product catalog Operating & maintenance instructions

Contents

Bacharach Portable Combustion Analyzer Instruction Manual pdf 13 page image

PCA3.0 SETTING UP THE PCA3.1 ScopeBefore using the PCA, you MUST:Setup• Check the batteries or plug in an Optional Power Supply (Section 3.2)• Connect the probe to the analyzer (Section 3.3)• Check the analyzer’s configuration (Section 3.4)3.2 PCA Power3.2.1 Checking and Replacing the BatteriesA fresh set of batteries is supplied with the PCA. Install the batteries asdescribed below. If a LOW BATTERY message is displayed when theanalyzer is turned on, replace the batteries.1. Remove the battery cover from the back of the PCA (Figure 3-1).2. Remove (and properly dispose of) any old batteries.3. Insert a fresh set of four AA alkaline batteries, making sure to installthem per the “+” and “–” markings shown in the battery compart-ment.4. Replace the battery cover.Figure 3-1. Battery ReplacementInstruction 0024-9219 3-1