25When more IP addresses are needed, set the Multi link mode configuration field to Enable(Figure 5-4). Table 5-3 provides a description of each field.Figure 5-4: Multi link mode configurationTable 5-3: Multi link mode configurationMulti link mode configurationMultiInterfacesConfig Enable or Disable. Enabling opens a dialogue window withadditional fields.OMC Link Select the interface used by the OMC link. It must be anenabled WAN interface or IPSec tunnel.S1AP Link Select the interface used by the S1 AP link. It must be anenabled WAN interface or IPSec tunnel.S1 Data Link Select the interface used by the S1 AP data link. It must be anenabled WAN interface or IPSec tunnel.X2AP Link Select the interface used by the X2 AP link. It must be anenabled WAN interface or IPSec tunnel.X2AP Data Link Select the interface used by the X2 AP data link. It must be anenabled WAN interface or IPSec tunnel.5.2.2 LANThe LAN interface is the local maintenance interface, which typically is used only for the initialconfiguration of the eNB during installation. The default IP address of the LAN interface is192.168.150.1. Normally you can leave the values as is.1. Go to Network > LAN to enter the LAN interface configuration page (Figure 5-5).
