BainUltra GEYSAIR Addendum To The Owner's Manual
                        | |
Contents
| 
TURBINETURBINE | geysair tmaddendum to the owner’s manualwww.bainultra.comPrinted in Canada. Copyright © september 2012 Bainultra inc. all rights reserved. 45100169some products, specifications, and services mentioned in this manual are describedin pending patent applications or are protected by patents.supersedes page 27 of owner’s Manual 17turBine witH geysair - eleCtriCal installation & PlumBingtURbIne wIth GeYsaIRelectrical installation & pluMBingthe turbine is connected to a 120V circuit.all electrical connections must be carried out bya certified electrician in accordance with localelectrical requirements and codes. special attentionmust be given to installation of bath’s power circuit,and more particularly to the following points:the electrical system must be connected to anindependent circuit protected by a new 20 aMpclass a ground fault circuit interrupter (gfci)and another one of 15 aMp for additonal options.this electrical circuit must imperatively be grounded.canaDa only: for permanently connected units.a green-colored terminal (or a wire connector marked g,gr, ground or grounding) is provided within the terminalcompartment (not applicable if unit supplied with an elec-tric plug). to reduce the risk of electrocution, connect thisterminal or connector to the grounding terminal of yourelectric service or supply panel with conductor equivalent insize to the circuit conductors supplying the equipment andbe 12 awg or more. install this unit in aCCordanCewith the Canadian eleCtriCal Code, Part 1.a service access is necessary. minimum dimensionsare: 22” x 18” (55 cm x 46 cm) to properly reach allelectrical components of the system.the inmix module (Chromatherapy) of the electronic control andthe turbine must be easily accessible at all times. make all connec-tions as indicated on diagram below. ensure that power circuitis disabled before proceeding with any electrical connec-tions. electrical cable feeding bath must be at least n° 12 awgcaliber. turbine must be connected to its own circuit, which,in turn must be connected directly in breaker panel withoutany interrupters or dimmer switches. Canada only: the junc-tion box must be attached to the wall at the height of at least1 1/2” (3.8 cm) from the ground.the geysair hose must be connected to the hot water supplyby a qualified plumber. a 3/8 inch male or 1/2 inch nPt hose bibbis supplied. for optimal performance, keep hose length toa minimum. set temperature on hot water heater no higher than140°f/60°C. for all the houses having to deal with specialwater conditions (hard, rust, sulfur, etc) the homeownershould already be aware of the specific measures that shouldbe taken for all his other appliances using water. the geysairdoes not need other measures than that.groundingaCCessConneCtionsPlumBing |
Related manuals for BainUltra GEYSAIR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine