TURBINEgeysair tmaddendum to the owner’s manual | TURBINE1 800 463.2187 From 8 a.m. to 8 p.m. Monday to Thursday (EST) From 8 a.m. to 5 p.m. on Friday (EST)Printed in Canada. Copyright © september 2012 Bainultra inc. all rights reserved. 45100169some products, specifications, and services mentioned in this manual are describedin pending patent applications or are protected by patents.20 supersedes page 31 of owner’s Manuala. to remove turBine witH geysairfrom its Present suPPortsB. to reinstall turBineturBine witH geysair - remote mounting turBine installation2 xA-4a-1 disconnect electrical supply to bath.a-2 disconnect wires going to turbine.a3 using a flathead screwdriver, loosenfitting.a-4 for ayoura® freestanding only:disconnect turbine at fitting by looseninglower and upper fitting with flatheadscrewdriver.a-5 Cut the electrical cable connecting theturbine to the geysair unit. this wire ismarked with a yellow label.B-1 mount turbine to wall or wall structureby inserting 1” (2.5 cm) screws inmounting holes.B-2 use as many 1 1/2” (4 cm) aBs or PvCpipes as necessary to connect turbine tobath. follow all relocation instructionsprovided in installation manual. to reducevibrations, avoid having air line pipestouch home structure.B-3 secure pipe at air output of turbine bydrilling a 1/8” (0.3 cm) hole and by using1/2” (1.3 cm) screw. (do not glue).B-4 strip the two ends of the cut cable. Con-nect each end to a terminal box. Connectthe two terminal boxes with minimum14awg 3-stranded cable.warning:test for grounding continuity betweenthe bath grounding terminal andbath power supply. failure to performthe grounding continuity test couldresult in serious personal injury.B-5 reconnect wires going to turbine.B-6 Connect bathtub’s power supply.iMportant • these stePs must Be eXeCuted By a Qualified eleCtriCian• geysair should not Be installed remotely