Baker SterilGARD III Advance Operator's Manual

Contents

Baker SterilGARD III Advance Operator's Manual Manual pdf 17 page image

Document: 333D012G5-18-2007- 16 -• Ultraviolet (UV) Light On / Off [Optional] – A bulb, which produces light in the ultraviolet range, may beused to help disinfect the work area. This switch controls the UV Light inside the work area if the UV Lightoption is installed. The viewscreen must be fully closed before the UV light will turn on. The FluorescentLight and the UV Light are interlocked. When the viewscreen is closed, turning the UV Light On willautomatically turn the Fluorescent Light Off. Turning the Fluorescent Light On will automatically turn theUV Light Off. The UV light will automatically shut off if the viewscreen is opened. A yellow indicator lightlocated below the switch will illuminate when the switch is on.• Fluorescent Light On / Off – This switch controls operation of the Fluorescent Light. The cabinet blowermust be on for the Fluorescent Light to operate. The Fluorescent Light and the UV Light are interlocked.When the viewscreen is closed, turning the UV Light On will automatically turn the Fluorescent Light Off.Turning the Fluorescent Light On will automatically turn the UV Light Off. A Blue indicator light locatedbelow the switch will illuminate when the switch is on.• Duplex Outlets On / Off – This switch controls the duplex outlets in the work area. A Blue indicator lightlocated below the switch will illuminate when the switch is on.• Blower On / Off – This switch controls the power to the cabinet blower. A Green indicator light locatedbelow the switch will illuminate when the switch is on.• Alarm reset / Sash level alarm – For normal operation, the viewscreen must be placed at the allowableopening of 8” or 10” [203.2mm or 254mm]. The sash alarm will be activated whenever the viewscreen israised above or lowered below this level. To mute the audible alarm, press the alarm reset button. Theindicator light located below the switch will continue to flash. After five minutes, if the conditions persist, thealarm will sound again to remind you to reposition the viewscreen to its proper level. You may press thealarm reset switch again to mute the audible alarm for an additional five minutes.Programmable Delay Off Time FunctionThe following procedure can be used to program a Delay Off time for UV, outlets, or fluorescent lights:NOTE - The device to be programmed should be in the OFF condition before you start programming.15 minute increment programming:1. Press and hold the pushbutton of the device you want to program.2. In about 3 seconds you will hear a short ‘beep’. This indicates that you have turned the device ON,are in the programming mode for the device, and have programmed it to turn OFF in 15 minutes.Release the pushbutton.3. Each subsequent press of the device pushbutton while in the programming mode will add 15 minutesto the Delay Off time. (e.g. pressing the pushbutton 3 additional times would set the delay to 60minutes, 15 min. initially plus 3 x 15 minutes additional delay times).4. The device control will remain in the programming mode for about 4 seconds if the pushbutton is notpressed.5. Once the programming mode for the device has ended the device can be turned OFF normally, ifdesired, by pressing the device pushbutton.6. The programmed device will turn OFF automatically at the end of the Delay Time.7. Each time a programmed device is turned off manually or automatically the programming is clearedand must be reentered, if desired.