Baldor 23H series Installation & Operating Manual

Also see for 23H Series: Installation & operating manual

Contents

Baldor 23H series Installation & Operating Manual Manual pdf 44 page image

Standard Run 3 Wire Control ModeFigure 2-18 Standard Run 3-Wire Connection DiagramSee Appendix C For Recommended Terminal Tightening TorquesNOTE: FOR 4-20MA INPUT MOVE JUMPER JP1 ON THE MAIN CONTROL BOARDTO THE LEFT TWO PINS.J1-8 OPEN disables the control and motor coasts to a stop. CLOSED allows current toflow in the motor and produce torque.J1-9 MOMENTARY CLOSED starts motor operation in the Forward direction. In JOG mode(J1-12 CLOSED), continuous CLOSED jogs motor in the Forward direction.J1-10 MOMENTARY CLOSED starts motor operation in the Reverse direction. In JOGmode(J1-12 CLOSED), CONTINUOUS closed JOGS motor in the Reverse direction.J1-11 When OPEN control removes power from motor and disables. Coasts or brakes tostop depending on Keypad Stop Mode parameter setting.J1-12 CLOSED places control in JOG mode, Forward and Reverse run are used to jog themotor.J1-13 OPEN selects ACC / DEC / S-CURVE group 1. CLOSED selects group 2.J1-14 CLOSED selects preset speed #1, (J1-12, will override this), OPEN allows speedcommand from Analog input #1 or #2.J1-15 OPEN to run, CLOSED to reset fault condition.J1-16 OPEN causes an external trip to be received by control. The control will disable anddisplay external trip when programmed "on". Factory preset is "off".2-33INSTALLATION12345678910111213141516171819202122SINE +SINE –COSINE +COSINE –EXCITATION +COMMONSHIELDNOT USEDAABBINDEXINDEXNOT USEDCOMMON+24VOPTO IN POWEROPTO OUT RETURN #1OPTO OUT RETURN #2OPTO OUT RETURN #3OPTO OUT RETURN #4ENABLEFORWARD RUNREVERSE RUNSTOPCLOSED = JOG SPEEDACCEL/DECEL/SELECTPRESET SPEED #1FAULT RESETEXTERNAL TRIPINPUT COMMONPROGRAMMABLE 0-5V OUTPUT (FACTORY PRESET: SPEED)PROGRAMMABLE 0-5V OUTPUT (FACTORY PRESET: CURRENT)J1232425262728293031323334353637383940414243440-5VDC OR0-10VDC OR4-20 mAANALOG GNDANALOG INPUT 1POT REFERENCEANALOG INPUT +2ANALOG INPUT -2ANALOG OUT 1ANALOG OUT 2USER COMMONOPTO OUT #1OPTO OUT #2OPTO OUT #3OPTO OUT #45kOhm COMMAND POTREFER TO POWERING THEOPTO-ISOLATED OUTPUTSBOTH CLOSED =FORWARDRESOLVERINPUTINCREMENTALPOSITIONOUTPUTMN723H-10/95 11/28/95 1:10 AM Page 45 (Black plate)