Section 1Receiving & InspectionReceiving & Inspection 1-1MN1230Receiving & Inspection Baldor Controls are thoroughly tested at the factory and carefully packaged for shipment.When you receive your control, there are several things you should do immediately.1. Observe the condition of the shipping container and report any damageimmediately to the commercial carrier that delivered your control.2. Remove the Control from the shipping container and remove all packingmaterials. The container and packing materials may be retained for futureshipment.3. Verify that the part number of the control you received is the same as the partnumber listed on your purchase order.4. Inspect the control for external physical damage that may have been sustainedduring shipment and report any damage immediately to the commercial carrierthat delivered your control.5. If the control is to be stored for several weeks before use, be sure that it isstored in a location that conforms to published storage humidity andtemperature specifications. (Refer to Section 7 of this manual).
