Baltech VP-3470 Operation Manual

Contents

Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
BALTECH VP
Conventions
Introduction
safety measures
Personnel safety
laser safety
technical characteristics
Delivery set
Design and operation of the display
Figure 3. Lower panel of the display unit
Figure 4. Front panel of the display unit
Marking and packing
Figure 6. BALTECH VP-3470 in the transportation case
Operation conditions and prestarting procedures
Accelerometer installation during vibration control
Installation recommendations
Accelerometer installation during the balancing and diagnostics
Laser tachometer installation
Angular marking of the rotor
Figure 9. Correction weights
Digital angle gauge
power connection
PC connection
Switching on
switching off
Programs and functions
general settings
Figure 20. Language
Connection of the vibration sensors
Figure 24. Channel 1
Figure 26. Add
Figure 29. Delete
Measurements
Setting of the measurement parameters
Overall
Routes
Figure 37. List of machines
Figure 39. Selection of the measurement channel
Figure 42. Measurement process in ROUTES function
Time waveform
Figure 44. Time waveform
Spectrum
Envelope
Figure 52. Envelope measuring
Envelope spectrum
Peak and phase
Figure 59. Peak and phase
Turning speed
Figure 62. Turning speed results
Balancing
Figure 64. New balancing settings
Figure 65. Initial run
Manual input
Re-balancing
Influence Coefficient Method (ICM)
Vector math
Reports
Report deletion
Transfer of the balancing reports to PC
Maintenance
troubleshooting
Storage and transportation
Warranty liability

Baltech VP-3470 Operation Manual Manual pdf 20 page image

20 Technical descriptionBALTECH VP-3470Operation manual2. Input «02 channel»3. Output for stroboscope and tachometerFigure 3. Lower panel of the display unit1. Plug for a network adapter2. USB inputThe display unit has a robust aluminum housing (IP 65) with a film keyboard onthe front panel. Data interchange between the display unit and PC is conducted viathe USB interface. The function keys and alphanumeric keyboard are located on thefront panel (Figure 4).To enter a letter press the corresponding button several times till the required letteris displayed. Press long (more than 2 seconds) to move to the next symbol.The button 0 is used for lacuna and full point.

/ 88

Related manuals for Baltech VP-3470

Baltech VP-3410 Operation Manual

This manual is suitable for:

VP-3470

manualsdatabase

Your AI-powered manual search engine