Bang & Olufsen BeoLab 5 User Manual

Also see for BeoLab 5: Instructions User manual

Contents

Bang & Olufsen BeoLab 5 User Manual Manual pdf 11 page image

11Adapt BeoLab 5 to your systemThe loudspeaker is set to Optionnumber 0 from the factory.Therefore, when you connect theloudspeaker to a Bang & Olufsenaudio or video system, it is notnecessary to change the Optionsetting. In this case, the loudspeakersare controlled via the Bang & Olufsensystem.However, when the loudspeaker isconnected to a non-Bang & Olufsensystem, you must change the Optionsetting. In this case, the Beo4 remotecontrol signals are received andprocessed by the loudspeakers. Twodifferent Option settings are available– which to use depends on yoursetup.If the LINE output level of yournon-Bang & Olufsen system exceeds2 V RMS, you must set the loudspeakers toaccommodate a higher input level(> 2 V RMS ≤ 4 V RMS).Option 0Option 1Option 4Option 0 (factory setup): Used if connected to aBang & Olufsen audio (or video) system.Option 1: Used if connected to a non-Bang &Olufsen system. You may have a Bang & Olufsentelevision in the same room, if you wish.Option 4: Used if connected to a non-Bang &Olufsen system – and you have an extra Bang &Olufsen audio system in the same room.A Beo4 remote control is used to change the‘Option’ and the LINE input level setting.To change the Option setting:> While holding down the • button, press LIST.> Let go of both buttons.> Press LIST repeatedly until OPTION? is shown inthe Beo4 display.> Press GO.> Press LIST repeatedly until L.OPT is shown in theBeo4 display.> Key in the appropriate Option number (0, 1or 4).The indicator light switches off briefly, confirmingthat the new Option number has been stored. Toensure that all loudspeakers are programmed tothe correct number, repeat the procedure for eachloudspeaker separately.To change the LINE input level setting:> Press LIST repeatedly until SOUND* is shown inthe Beo4 display.> Press GO.> Key in the appropriate LINE input level number(1 if LINE input level < 2 V RMS; 2 if LINE inputlevel > 2 V RMS ≤ 4 V RMS).The indicator light switches off briefly, confirmingthat the new LINE input level has been stored. Toensure that all loudspeakers are set to the sameLINE input level, repeat the procedure for eachloudspeaker separately.*Must be added to the Beo4 LIST-function. To doso, refer to the Beo4 Guide.