Bang & Olufsen BeoLab 5 User Manual

Also see for BeoLab 5: Instructions User manual

Contents

Bang & Olufsen BeoLab 5 User Manual Manual pdf 14 page image

14 Use the PIN code systemThe loudspeaker has a built-in PINcode protection system. You decidewhether or not to activate it.If you choose to activate the PINcode system, and if the loudspeakeris disconnected from the mains formore than 15–30 minutes, it willonly play for a five minute periodupon reconnection – and thenautomatically switch to standby. Inthis case, you must key in your ownpersonally chosen PIN code with aBeo4 remote control, to unlock theloudspeaker.PIN code system setupFor your own convenience we suggest thatyou choose the same four-digit PIN code forall your Bang & Olufsen products. However,you cannot use the code ‘0000’, as this isreserved for use when deactivating the PINcode system.To activate the PIN code systemYou activate the PIN code system for eachloudspeaker in your setup separately.While BeoLab 5 is in standby…> Press ss, ss, and STOP in quick succession onthe Beo4 remote control.The indicator light shines intermittently red(0.5 sec.) and green (1 sec.).> Within 10 seconds, press the touch field on topof the loudspeaker you wish to activate.The loudspeaker confirms your selection with asound signal.> Key in a four-digit PIN code of your ownchoice*.The loudspeaker confirms each digit with asound signal.> Press GO to accept your four-digit code.The loudspeaker confirms this with a soundsignal.> To confirm your chosen code, key in the four-digit code again*.The loudspeaker again confirms each digit witha sound signal.> Press GO to store your four-digit code.The loudspeaker confirms this with a soundsignal.If the PIN code is accepted, the indicator lightshines red again – indicating that the loudspeakeris in standby and ready for use.If it is not accepted, the loudspeaker emits asound signal, and you will have to start over againwith the four-digit code.Press the touch field on the loudspeaker you wishto activate (while you are pressing the field, theindicator light quickly flashes red).If you wish to skip an ongoing activation, you cando so by touching the touch field again (orpressing EXIT on the Beo4 remote control).We recommend that you disconnect your otherBang & Olufsen products in the room from themains while setting-up the PIN code system. Thisprevents them from, for example, switching on,when you press the buttons on the Beo4 remotecontrol.For an overview of the indicator lights and thesound signals, refer to page 17.*NOTE! If you make a mistake, press STOP andthen start digit entry over again.