Banner SLLVE23-350 Instruction Manual

Contents

Banner SLLVE23-350 Instruction Manual Manual pdf 17 page image

Scan Code Input (Available with 8-Conductor Models)High Signal: 10 to 30 V dc at 30 mA typicalLow Signal: 0 to 3 V dcScan Code Selection: 8-pin/8-wire connection only (5-pin systems areScan Code 1)• Select Scan Code 1 by connecting pin 8 (violet wire) to 0 V dc orleaving it open (not connected)• Select Scan Code 2 by connecting pin 8 (violet wire) to +24 V dcStatus IndicatorsAmber Run Mode Indicator: indicates the System is ready foroperationBi-color (red/green) Status indicator: indicates general system andoutput statusBi-color (red/green) Alignment Status indicators: indicate condition(clear or blocked beam) of a defined group of beams (±35 mm ofindicator)7-Segment Diagnostic indicator (1 digit): indicates proper operation,scan code, error code, or total number of blocked beamsAmbient Light Immunity10,000 lux at 5° angle of incidenceStrobe Light ImmunityTotally immune to one Federal Signal Corp. "Fireball" model FB2PSTstrobe4.3 Emitter SpecificationsEmitter Elements WavelengthInfrared LEDs, 850 nm at peak emissionFault Output Switching CapacityCurrent-sourcing (PNP) solid-state output, 24 V dc at 70 mA maximumPosition ID Input (Available with 8-Conductor Models)Input connected to +24 V dc to identify emitter's position as a stand-aloneStatus IndicatorsOne bi-color (Red/Green) Status Indicator: indicates operating mode,lockout or power Off condition7-Segment Diagnostic indicator (1 digit): indicates proper operation,scan code, or error codeScan Code Input (Available with 8-Conductor Models)High Signal: 10 to 30 V dc at 30 mA typicalLow Signal: 0 to 3 V dcScan Code Selection: 8-pin/8-wire connection only (5-pin systems areScan Code 1)• Select Scan Code 1 by connecting pin 8 (violet wire) to 0 V dcor leaving it open (not connected)• Select Scan Code 2 by connecting pin 8 (violet wire) to +24 VdcEZ-SCREEN® LS Basic Safety Light Screenwww.bannerengineering.com - Tel: 763.544.3164 17