3. ConnectionsHow to set the Input selection mode1. Press ADJUST or ENTER to start up the Adjustment Mode.The Adjustment Mode menu will be displayed. (menu 3-2)2. Push the cursor key ↑ or ↓ to highlight Installation. (menu 3-3)3. Press ENTER to select.The Installation menu will be displayed. (menu 3-4)4. Push the cursor key ↑ or ↓ to highlight Input Slots. (menu 3-5)5. Press ENTER to select.The Input Slots menu will be displayed. (menu 3-6)6. Push the cursor key ↑ or ↓ to highlight Slot Selector. (menu 3-7)7. Press ENTER to toggle between [AUTOMATIC] or [MANUAL].8. Press EXIT several times to leave the adjustment mode.ADJUSTMENT MODESelect a path from below :RANDOM ACCESSINSTALLATIONSERVICESelect with ↑ or ↓then to returnMenu 3-2ADJUSTMENT MODESelect a path from below :RANDOM ACCESSINSTALLATIONSERVICESelect with ↑ or ↓then to returnMenu 3-3INSTALLATIONINPUT SLOTSNO SIGNALBARCO LOGOLENSMENU POSITION[CENTER]800 PERIPHERALMORE ...Select with ↑ or ↓then to returnMenu 3-4INSTALLATIONINPUT SLOTSNO SIGNALBARCO LOGOLENSMENU POSITION[CENTER]800 PERIPHERALMORE ...Select with ↑ or ↓then to returnMenu 3-5INPUT SLOTSSLOT SELECTOR [AUTOMATIC]x 1. RGB [HS&VS]- 2. RGB [HS&VS]- 3. NO MODULE- 4. NO MODULE- 5. NO MODULE- 6. NO MODULESelect with ↑ or ↓ to toggle to returnMenu 3-6INPUT SLOTSSLOT SELECTOR [AUTOMATIC]x 1. RGB [HS&VS]- 2. RGB [HS&VS]- 3. NO MODULE- 4. NO MODULE- 5. NO MODULE- 6. NO MODULESelect with ↑ or ↓ to toggle to returnMenu 3-73.6.3 Inputs via RCVDS05OverviewWhen using a RCVDS05, it is recommended to use a 5-Cable Output module in the RCVDS. The outputs of this module have to beconnected to the 5-Cable Input (Input Slot 1) of the projector. To switch the projector in the 5-Cable mode see chapter ’Installationmode’.3.6.4 Input 1Which signals can be connected to Input 1?Connector name/ Input SignalR G B H VRGBHV R G B H VRGBS R G B S -RGsB R Gs B - -Composite Video 1 - Video - - -Super Video 1 - Y - - CR5976420 BARCOREALITY SIM 6 ULTRA 14052003 17
