Barco CS-100 Installation Manual
Also see for ClickShare CS-100: Safety manualInstallation manualUser guideInstallation manualUser guide
                                                                | |
Contents
| 
4. CS-100 Installation6,5(2x)161,84Image 4-1Mounting holes2. Insert a plug in each hole (if needed, depends on the wall or ceiling type) and drive in 2 screws. Do not drive in the screwscompletely.Note: Mounting screws and plugs are not included in the CS-100 box . The type of screws and plugs depend on the type ofwall (stone, wood, plasterboard, ...) you are mounting the Base Unit to. Make sure the head of the screw is not largerthan the hole in the bottom plate of the Base Unit (< 6.5 mm).3. Hook the Base Unit on both screw heads and slide the Base Unit downwards until it is fixed.4.4 Video signal connections to the Base unitC AUTION : Make sure the Base Unit is installed properly before connecting.About Video signal connectionA single screen can be connected to the Base unit.To connect a display, an HDMI connection should be made between the Base Unit and the display.To connect1. Connect the Base unit to the display using a display cable.Note: No display cables are included in the ClickShare box at purchase.When setting up a display configuration, connect the HDMI cable to the display. When necessary, use an adapter piece to connectto a display port or a DVI port on the display side.HDMIImage 4-2Display connection14 R5900022 CS-100 16/02/2016 |
Related manuals for Barco ClickShare CS-100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine