Barco CS-100 Installation Manual
Also see for ClickShare CS-100: Safety manualInstallation manualUser guideInstallation manualUser guide
                                                                | |
Contents
| 
6. CS-100 ConfiguratorHow to enable update over Wi-Fi1. Log in to the Configurator.2. Click System → Buttons.3. Check the check box in front of Update Buttons over Wi-Fi.6.19 Firmware UpdateAbout Software updateThe software of the Base Unit can be updated via the web interface. The latest version of the software is available on Barco’swebsite.Image 6-27Firmware updateAbout automatic firmware updatesAutomatic firmware updates can be triggered in 3 ways:• triggered via a scheduled time• triggered at boot• manual triggerHow to start an Automatic firmware update1. Log in to the Configurator.2. Click Support & Updates → Firmware.3. To check immediately if new software versions are available, click on Check now for updates.The system checks if new firmware is available and uploads this automatically to the Base Unit.4. To ask a confirmation before installing the software update, check the check box in front of Ask confirmation... .5. To check for new software at boot, check the check box Check at boot.During booting up, when new firmware is found, this firmware will be loaded and the Base Unit will reboot.6. To use a schedule, check the check box in front of Check on schedule.Click on the drop down box and select the desired time slot.Note: Select a time slot where you are sure the Base Unit will not be in use.When new firmware is available, this firmware will be loaded and the Base Unit will reboot.42 R5900022 CS-100 16/02/2016 |
Related manuals for Barco ClickShare CS-100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine