Barco UDX 4K22 Installation Manual

Also see for UDX 4K22: User manual User manual User manual Installation manual User manual

Contents

Barco UDX 4K22 Installation Manual Manual pdf 57 page image

5. Input & CommunicationR5906113 UDX 07/07/2017 535.3 Installation of an input board or a communication boardW ARNING : The procedures below may only be performed by Barco trained and qualified technicians.C AUTION: Always wear a wrist band which is connected to the ground while handling the electrostatic dis-charge (ESD) sensitive parts.Necessary toolsPH1 Phillips screwdriverThe procedure below is applicable to all the input modules of the Input & Communication Unit of the projector.How to install1. Switch off the projector and unplug the power cord at the projector back side.2. Push the input module in the Input & Communication Unit using the handles. Make sure the module seats in its sliders (2).Pull in the module until the contacts (3) are fully inserted into the connectors.Image 5-43. Tighten the captive screws of the input module.23 2