72 R5906113 UDX 07/07/20176. Getting Started6.2 Power on projectorHow to power on1. Press the mains switch at the side of the projector to switch on this projector.Image 6-1Mains switch- When ’0’ is pressed, the projector is switched off.- When ’I’ is pressed, the projector is switched on.The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved. Once in standbymode, the Power on/off button will be lit WHITE, but the display will be off.2. Press the Power on/off button on the projector, or the Power On button on the remote control.The projector will continue to power on mode. The Power on/off button will blink until the projector is ready. Once the projectoris ready, the Power button will be lit BLUE.The start up screen is displayed on the touch panel and when fully started up, it changes to the overview screen.12Image 6-2The current mains input voltage is indicated on the voltmeter just above the power switch.The background image of the startup screen and info screens can be changed with Projector Toolset with aninstalled UDX plug-in.Status overviewOnce the projector is started, press Status to get an overview of parameters such as :
