R5906112-06 UDX series104Next to an individual projector address, each projector has also a broadcast address for group control.How to change1. In the main menu, select System Settings → Communication → IR Control.Image 9-9: Communication menu, IR controlThe IR control menu is displayed.Image 9-10: IR control menu2. Select the current projector address and enter a new address.3. Select APPLY and click OK to apply the changes.From now on the projector will only listen to this new address and to its broadcast address.9.3.3 IR sensorsWhat can be done?Each IR sensor can be individually disabled or enabled.When all sensors are turned off, the projector will no longer respond to signals from the remote control. To re-enable the sensors, use the menu keypad on the projector.How to disable1. In the main menu, select System Settings → Communication → IR Control.Image 9-11: Communication menu, IR controlThe IR control menu is displayed.GUI – System Settings
