R5906112-06 UDX series 4545° 45° 45° 45° 45° 45°Image 4-7: RCU to one of the IR sensorsUsing the RCU in combination with a 3D emitterWhen using a 3D emitter that radiates IR beams (e. g. the optional 3D emitter that Barco provides), the IRbeams of the 3D emitter may interfere with the IR communication between projector and the RCU.If such interference occurs, connect the RCU to the projector using the remote cable with XLR connector. It isalso be advised to turn the IR receivers of the projector off to avoid the 3D emitter interference. The IRreceivers can be turned off in the GUI: System Settings” → “Communication” →“IR Control “.4.6 Projector AddressProjector addressAddress installed in the projector to be individually controlled.Broadcast addressProjector will always execute the command coming from a RCU programmed with that broadcastaddress.4.6.1 Controlling the projectorWhy a projector address?As more than one projector can be installed in a room, each projector should be separately addressable withan RCU or computer. Therefore each projector has its own address.Set up an individual Projector AddressThe set up of a projector address can be done via the software.Projector controllingWhen the address is set, the projector can be controlled now:• with the RCU: only for addresses between 1 and 31.Broadcast AddressEvery projector has a broadcast (common) address '0' or '1'. The default address is '0'.Getting Started
