Mobile Computer MC 92N0 exType 17-A1A.-………… and Type B7-A2A.-………… OperationTechnical data subject to change without notice.Revision B / 03/2019 59/79US and CanadaCo-located statementTo comply with FCC RF exposure compliance requirement, the antenna used for thistransmitter must not be co-located or operating in conjunction with any othertransmitter/antenna except those already approved in this filling.Handheld DevicesThis device was tested for typical body-worn operation. Use only BARTEC tested andapproved belt-clips, holsters, and similar accessories to ensure FCC Compliance. The useof third-party belt-clips, holsters, and similar accessories may not comply with FCC RFexposure compliance requirements, and should be avoided.The MC 92N0 ex should only be worn on the body when switched off.Handheld devicesTo comply with the FCC guidelines for high frequency devices, the aerial of the transmittershould be used in the direct vicinity of, or in an operation unit with, other transmitters/aerialswith the exception of those approved in this document.SD cardThe SD card slot provides a secondary, non-volatile memory. The slot is under the keypadof the MC 92N0 ex . Further information is provided in the documentation supplied with thecard. Observe the manufacturer’s recommendations on use.
