BaseWall, Tel: +31-74-2491004, Fax: +31-74-259393445VPN Configuration – Tunnel to Basewall Unit• VPN Tunnel List– here you can add a new tunnel or change an existing one from the list Therouter can setup a maximum of 50 tunnels.• Tunnel Name– In order to distinguish the tunnels, you have to give the “Tunnel” a name..• Tunnel – Only after you enable the tunnel check box, the tunnel can be connected.• WAN port – You can choose WAN1, WAN2 or Any to make the VPN connection.• Local Security Network– These entries identify the private network on this VPN router, thehosts of which can use the LAN-to-LAN connection. You can choose a single IP address, the subnet,or a selected IP range to make VPN LAN-to-LAN connection.• Remote Security Network– These entries identify the private network on the remote peer VPNrouter whose hosts can use the LAN-to-LAN connection. You can choose a single IP address, the subnet,or a selected IP range to make VPN connection• Remote Security Gateway – You can select the remote side IP address (WAN IP address) as yourremote side security gateway• Preshared Key – Choose a shared secret for this entry, this must be the same on both units.• ActionConnect – this button will initiate the tunnelSubmit Query – this button will add the policyVPN Configuration – Tunnel to BaseWall Client