Basler A102K User Manual

Also see for A102K: User manual

Contents

Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
Camera Models
Performance Specifications
Environmental Requirements
Ventilation
Connections
Pin Assignments
Connector Types
Cable Information
Input Signals
Output Signals
Video Data
Video Data Output Modes
Integrate Enabled Signal
RS-644 Serial Communication
Converting Camera Link Output to RS-644 with a k-BIC
Functional Description
Exposure Time Control
in ExSync Level-Controlled Mode
in ExSync Programmable Mode
Free-run Operation
in Free-run Programmable Mode
Low Smear
Gain and Offset
Setting the Gain
Setting the Gain with Vertical Binning Disabled
Setting the Gain with Vertical Binning Enabled
Setting the Offset
Digital Shift
Digital Shift in 8 bit Output Mode
Precautions When Using Digital Shift
Area of Interest (AOI)
AOI Setup Guidelines
Changes to the Pixel Timing and Output with AOI
Binning
Full Binning
Test Images
Test Image Two
Configuration Sets
Camera Status
Configuring the Camera with the Camera Configuration Tool (CCT+)
Configuration Tool Help
Configuring the Camera with Binary Programming Commands
Command Frame and Response Format
Error Checking
Example Commands
Calculating the Block Check Character
Commands for Setting Camera Parameters
Exposure Time Control Mode
Timer 1
Area of Interest Starting Column
Area of Interest Starting Line
Gain
Horizontal Binning
Test Image Command
Query Commands
Read Serial Number
Read Microcontroller Firmware Version
Read Minimum Gain Setting
Copy the Factory Set or a User Set into the Work Set
Copy Work Set into a User Set
Select the Startup Pointer
Camera Status Command
Bitrate Command
Camera Reset Command
Camera Dimensions and Mounting Facilities
C-Mount Adapter Dimensions
Positioning Accuracy of the Sensor Chip
Fault Finding Using the Camera LED
Troubleshooting Charts
Poor Quality Image
Interfacing

Basler A102K User Manual Manual pdf 86 page image

Configuring the Camera4-24 BASLER A102kDRAFT4.2.6.2 Copy Work Set into a User SetPurpose: To copy the Work Set into one of the 15 User Sets. See Section 3.11 for an explanation ofconfiguration sets.Type: This is a write only command.Write Command: Cmd-ID R/W-Flag Data Length Data0x46 0 1 1 ByteResponse: NoneData Format: Byte 1 An ID that specifies the user set.(see the table below).Set ID Set0x01 User Set 10x02 User Set 20x03 User Set 30x04 User Set 40x05 User Set 50x06 User Set 60x07 User Set 70x08 User Set 80x09 User Set 90x0A User Set 100x0B User Set 110x0C User Set 120x0D User Set 130x0E User Set 140x0F User Set 15

/ 105

Related manuals for Basler A102K

Basler daA2500-60mc-SD820-DB8 Quick Install Manual

This manual is suitable for:

A102K

manualsdatabase

Your AI-powered manual search engine