TroubleshootingBasler A500k Series 6-1PRELIMINARY6 TroubleshootingFault finding using the camera LED is described in section 6.1.6.1 LEDA500k cameras regularly perform self tests. Detected errors are signaled by blinking of the LEDon the back of the camera. The number of pulses indicate the detected error. If several error statesare present, the LED outputs the error codes in succession.See Table 6-1 for the description of the pulses and the error states.LED DescriptionOrange and onContinuousThe camera has power and is OK.3 pulses ExSync has not changed state for 5 seconds or longer. If you are not supplyingan ExSync signal to the camera, this is a normal condition and should be ignored.Otherwise check the cable and the ExSync generating device.5 pulses The Work Set could not be stored into a User set.Please contact Basler support.6 pulses A User Set or the Factory Set could not be loaded into the Work Set.Please contact Basler support.7 pulses A valid list of commands was not available.Please contact Basler support.8 pulses The FPGA could not be configured. Please contact Basler SupportTable 6-1: Camera Status Indicators
