Image Acquisition Control92 Basler scout7.5 The Frame Start Trigger in StandardModeFor more information about standard mode and legacy mode and how to set them, see Section 7.1on page 77.The frame start trigger is used to begin frame acquisition. Assuming that the camera is in a "waitingfor frame start trigger" acquisition status, it will begin a frame acquisition each time it receives aframe start trigger signal.Note that in order for the camera to be in a "waiting for frame start trigger" acquisition status: The Acquisition Mode parameter must be set correctly. A proper Acquisition Start command must be applied to the camera. A proper acquisition start trigger signal must be applied to the camera (if the Trigger Modeparameter for the acquisition start trigger is set to on).For more information about the Acquisition Mode parameter and about Acquisition Start andAcquisition Stop commands, see Section 7.2 on page 79 and Section 7.3 on page 83.For more information about the acquisition start trigger, and about the acquisition status, seeSection 7.2 on page 79 and Section 7.4 on page 85.Referring to the use case diagrams that appear in Section 7.8 on page 119 can help you understandthe explanations of the frame start trigger.This section only applies if the standard mode is enabled for image acquisitioncontrol.When the camera is started for the first time after delivery from the factory theimage acquisition control will not be in standard mode but in legacy mode.Use the legacy mode only if you want to operate the camera together withprevious cameras not featuring the standard mode.
