Basler ace CL Installation And Setup Manual

Also see for aviator: User manual Quick installation guide Installation and setup guide

Contents

Basler ace CL Installation And Setup Manual Manual pdf 51 page image

AW00061111000 Installing a FireWire CameraInstallation and Setup Guide for ace CL, aviator, beat, pilot, racer, runner, and scout Cameras (Windows) 455.2 Software and Hardware Installation5.2.1 Precautions5.2.2 Installing the Basler pylon Camera SoftwareSuiteTo install the Basler pylon Camera Software Suite for use with a FireWire camera, follow theinstructions in Chapter 3 on page 3.Before installing a Basler FireWire camera, read the precautions in thescout-f User’s Manual (AW000115).Uninstalling pylon software while the camera is connected to the IEEE 1394bus may cause a bluescreen.Make sure to unplug the plug of the IEEE 1394 cable from the camera before youstart uninstalling pylon software. If you can not unplug the plug switch off camerapower.During installation of the Basler pylon 1394 camera driver, the current camera-driver associations may be changed.Depending on the conditions before and during installation, you will find yourFireWire camera associated with one of the following camera drivers after theinstallation: generic 1394 desktop camera driver Basler BCAM 1394 camera driver (from a previous installation of BCAMsoftware) Basler pylon 1394 camera driverFor information about checking and, if necessary, changing the current cameradriver association, see Section 5.2.3 on page 46.