Basler ace CL Installation And Setup Manual

Also see for aviator: User manual Quick installation guide Installation and setup guide

Contents

Basler ace CL Installation And Setup Manual Manual pdf 59 page image

AW00061111000 Installing a Camera Link CameraInstallation and Setup Guide for ace CL, aviator, beat, pilot, racer, runner, and scout Cameras (Windows) 536.3.3 InstallationTo install the camera hardware, follow these steps:1. Make sure that your camera power supply is not connected to the camera and that thepower to your host computer is switched off.2. For ace and aviator cameras: Remove the cap or the seal from the lens mount on the cameraand mount a lens on the camera.For beat and racer cameras: Remove the seal from the camera front. Attach a suitable lensadapter to the camera and mount a lens on the camera.3. Mount the camera in your test setup.4. For aviator cameras: Plug one end of a Camera Link cable into the MDR connector of thecamera and the other end of the Camera Link cable into the base configuration connector ofyour frame grabber.5. For ace, beat, and racer cameras:a. Plug one end of a Camera Link cable into the base SDR connector of the camera and theother end of the Camera Link cable into the base configuration connector of your framegrabber.b. Plug one end of a Camera Link cable into the medium/full SDR connector of the cameraand the other end of the Camera Link cable into the medium/full configuration connector ofyour frame grabber.6. Make sure that the connectors on the cable are securely fastened to the camera and the framegrabber. If the connectors are loose, they will cause problems with your images.7. Switch on the power to your host computer and let the computer boot up.8. For aviator cameras or if you are not using Power over Camera Link (PoCL):a. Connect the plug of the power supply’s output cable to the 6-pin power connector of thecamera.b. Plug the power supply into an AC outlet.Hardware installation is complete. Continue with the software installation procedure.