CADDX NX-6 User Manual

Also see for NX-6: Application note User manual

Contents

CADDX NX-6 User Manual Manual pdf 7 page image

7KEYPAD FUNCTIONSARMING YOUR SYSTEM IN THE “AWAY” MODEAWAY is used when the user is away from the premise and wants the interiorprotected. Listed below are the steps to arm in the AWAY Mode:Step 1 Close all protected doors and windows.• Ready light will be on or flashing when all protected zones andsensors are secure. NOTE: If any zones are bypassed, a sensorin that zone can be violated without affecting theready light.• The security system will not arm if theready light is not on orflashing.• If thepower light is off, you have no AC power. Restore power ifpossible. If not, contact your installing company listed on page 1 ofthis booklet for service.Step 2 • Enter your 4 or 6 digit user code to arm the system.• The armed and exit lights will illuminate.• You may now leave the building.Note: The exit light will flash rapidly for the last 10 seconds of the exit delayas a warning to the user that the exit time is about to expire. The user maywish to disarm and rearm the system if more time is needed.ARMING YOUR SYSTEM IN THE “STAY” MODESTAY is used when the user is inside the premise and wants protection aroundthe perimeter. Listed below are the steps to arm in the STAY Mode:Step 1 Close all protected doors and windows.• Ready light must be on or flashing when all protected zones andsensors are secure. NOTE: If any zones are bypassed, a sensorin that zone can be violated without affecting theready light.• The security system will not arm if theready light is not on orflashing.• If thepower light is off, you have no AC power. Restore power ifpossible. If not, contact your installing company listed on page 1 ofthis booklet for service.Step 2 • Enter your 4 or 6 digit user code.• If “Auto Bypass” is enabled, all interior zones will be bypassed if youdo not leave through a designated entry/exit door. If Auto Bypass isenabled, omit Step 3.• When “Auto Instant” is enabled, if you do not leave through adesignated entry/exit door theinstant light will illuminate indicatingthat the entry/exit doors no longer have an entry delay. If “AutoInstant” is enabled, omit Step 4.