CADDX NX-6 User Manual

Also see for NX-6: Application note User manual

Contents

CADDX NX-6 User Manual Manual pdf 9 page image

9CANCEL / ABORT FEATURE (Optional, see page 1)Thecancel light will flash during an abort delay time. If a code is enteredfollowed by the [CANCEL] key while this light is flashing, all abortable reports willstop the communication process. Entering a code followed by the [CANCEL] keyduring or after an alarm report to the central station will cause thecancel light tocome on. It will stay on until the central station has received the cancel report.BYPASSING ZONESIf you wish to bypass one or more zones, this must be done while the system is inthe disarmed state. The following steps are used for bypassing zones:Step 1 Press the [BYPASS] key.Step 2 Enter user code, if required (optional). Thebypass light flashes.Step 3 Enter 1 or 2 digits indicating the zone you wish to bypass. (Example:Press the [1] key for zone 1, press [1] - [2] for zone 12.)Step 4 Press the [BYPASS] key again.Step 5 The correspondingzone light will illuminate indicating the zone hasbeen bypassed. Repeat steps 3 and 4 for any other zone(s) thatneed to be bypassed.Step 6 Press the [BYPASS] key again -or- press the [#] key to exit theBypass Mode. Thebypass light will stop flashing upon exiting theBypass Mode.GROUP BYPASSBy pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] keyagain, all zones that are designated as group bypass zones will be bypassed.Press the [BYPASS] key again to exit group bypassing.UNBYPASSINGTo manually unbypass zones, perform the bypassing procedure on a zone that isalready bypassed. The corresponding light for that zone will go off whenunbypassed. NOTE: All zones will automatically be unbypassed each timethe system is disarmed.TURNING THE DOOR CHIME ON AND OFFThe door chime is turned on or off by pressing the [CHIME] key while the systemis in the disarmed state. If the chime is on thechime light will be illuminated. If thechime is off, thechime light will be off. Each press of the [CHIME] key will togglethe chime feature on/off and produce a momentary ding-dong sound.