CB ELECTRONICS TMC-1 Reference
Also see for TMC-1: Technical guideUser guideSetup guideUser guide
                                                                                              | |
Contents
| 
TMC-1 Reference Manual14 September 2018 CB Electronics 19 Version 6.0AAuuttoo MMooddee::The Auto Mode pages (shown below) can be selected from the Select Page screen({Select} + [Page] to access) , You can switch back to the Meters page at any time usingthe [Page] key alone.The Auto mode is controlled by transport tallies; two GPI inputs are provided Play andRecord and Hui via the USB port. If there is no Play tally output from your DAW you can useeither MTC via the USB connector or LTC via the GPIO connector as a play tally. You canchange the polarity of the GPIO inputs in the Setup menu. You can also program the Userkey to act as a Play or record Start/Stop.For each output there is an enable key (Blue = Enabled) and then Play Start, Play Stop,Record Start, Record Stop, where you can determine the action. This provides anequivalent to the Before/During/After selection used in the USAAuto Mute PageEnable/disable different outputson state change there are threechoices on change of state 1) NoChange, 2) Mute, 3) Enable. Theaction is only performed onchange. To set, select line using[<] and [>] then depress the Selectkey. The Enable line is used toenable disable individual columnsAuto Studio L/SNot yet AvailableBefore, During and After stylemonitor control of Studio L/Soutput. Switching on change ofstate as per Auto mute. To set,select line using [<] and [>] thendepress the Select key forOff/Mute/Enable of the selectedsources. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine