Chapter 3: Software Installation and Setup62 SmartSwitch Router 2000 Getting Started GuideSetting Basic System InformationUse the procedure in this section to set the following system information:• System time and date• System name• System location• Contact name (the person to contact regarding this SSR 2000)Note: Some of the commands in this procedure accept a string value. String values canbe up a maximum of 255 characters in length, including blank spaces. Surroundstrings that contain blanks with quotation marks (example: “string with internalblanks”).To set the system information:1. Ensure that you are in Enable mode by entering the enable command in the CLI.2. Use the following commands to set the system time and date and then verify thesettingHere is an example:3. Ensure that you are in Configure mode by entering the configure command in theCLI. The commands in Step 4 through Step 10 can be entered only from Configuremode.4. Use the following commands to set the system name, location, and contactinformation:set date year month day hour minute second system show datessr# system set date year 1998 month january day 19 hour 11 minute 54second 0Time changed to: Mon Jan 19 11:54:00 1998ssr# system show dateCurrent time: Mon Jan 19 11:54:04 1998system set name ""system set location ""system set contact ""
