Installing the 9E423-36 Module2-4Installing the Module in the SmartSwitch 9000ChassisTo install the 9E423-36 Module in the SmartSwitch 9000 chassis, follow the stepsbelow:1. Remove the blank panel, covering the slot in which the module will bemounted. All other slots must be covered to ensure proper airflow andcooling.2. Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000chassis to your wrist. Plug the other end into the jack for the ESD Wrist Strapin the lower right corner of the SmartSwitch 9000 chassis shown in Figure 2-2.3. Install the module in the chassis by sliding it into slots and locking down boththe top and bottom plastic tabs, as shown in Figure 2-2. Take care that themodule is between the card guides as shown, it slides in straight, and engagesthe backplane connectors properly.