DELHF-UA User’s Guide2-1CHAPTER 2INSTALLATIONThis chapter contains instructions for the following items:• Unpacking the DELHF (Section 2.1)• Installing FPIMs (Section 2.2)• Installing a DELHF (Section 2.3)To install the DELHF and FPIMs, you need the following items:• Antistatic wrist strap (provided with the MultiSwitch 700 chassis orstandalone hub)• Phillips screwdriver2.1 UNPACKING THE DELHFUnpack the DELHF-UA as follows:1. Remove the shipping box material covering the DELHF-UA.2. Carefully remove the module from the shipping box. Leave themodule in its non-conductive bag until you are ready to install it.3. Attach the antistatic wrist strap. If the HSIM is to be installed in astandalone hub, refer to the instructions on the antistatic wrist strappackage. If the HSIM is to be installed in an interface module, refer tothe applicable interface module User’s Guide.4. After removing the module from its non-conductive bag, visuallyinspect the device. If you notice any signs of damage, contact yourDIGITAL representative.! The DELHF-UA and the host module or hub are sensitive tostatic discharges. Use a grounding strap and observe all staticprecautions during this procedure. Failure to do so could resultin damage to the DELHF-UA, host module or hub.
