The FDDI/Ethernet Translation Configuration ScreenDELHF-UA User’s Guide3-293.9.3 Configuring the DELHF-UA for Full DuplexOperationTo configure the DELHF-UA to operate in full duplex mode, completethe following steps.1. Use the arrow keys to highlight the [STANDARD FDDI] field.2. Use the SPACE bar to toggle between [STANDARD FDDI] and[FULL DUPLEX].3. With [FULL DUPLEX] selected, use the arrow keys to highlight theSAVE command at the bottom of the screen, then press ENTER. The“Saved OK” message displays indicating that the changes have beensaved to memory.3.10 THE FDDI/ETHERNET TRANSLATIONCONFIGURATION SCREENTo access the FDDI/Ethernet Translation Configuration screen from theDELHF-UA Setup screen, use the arrow keys to highlight theFDDI/Ethernet Translation Configuration menu item on theDELHF-UA Setup screen and press ENTER. The FDDI/EthernetTranslation Configuration screen, Figure 3-15, displays.[STANDARD FDDI] is the default setting for the SETOPERATION MODE field of the DELHF-UA.When the SAVE command is executed, both ports of theDELHF-UA begin operating in full duplex mode.
