Chapter 2: Unpacking and Installing the FN100Page 2-4Fast Network 100 User Guide3. Secure the FN100 with the rack-mount fasteners by inserting andsecuring a fastener through each of the four slots in the rack-mountbrackets, as shown in Figure 2-3.Figure 2-3 Rack-mounting the FN1004. Once the FN100 is installed, plug the AC power cord into the ACpower connector on the rear of the FN100 chassis. Plug the other endof the power cord into a three-prong grounded outlet.2.3.3 Checking the Power-up Diagnostics SequenceBefore connecting any devices to the FN100, power on the unit andobserve the power-up diagnostics sequence to check for proper operation.To observe the power-up diagnostics sequence completely, you may wantto repeat it. To restart the power-up sequence, turn the power switch OFF,then ON again, or press the reset button on the front panel.When you power up the FN100, the following occurs:1. All LEDs, except for the Port Link LEDs, turn on for one second.2. The Power (Pwr) LED remains on.3. The Ready LED starts flashing.4. After several seconds, the Port Link and ACT LEDs flash briefly.FastenersRack1X 2X 3X 4X 5X 6X 7X 8X9X 10X 11X 12X 13X 14X 15X 16X13 14 15 16Link2 31 4 5 6 7 89 10 11 12StatusLinkStatusSelectTX ActResetReadyFN100-16NMS PortPortStatusMode100LinkStatusLinkStatus19TXTXRXRX RX Col UsrPwr Fasteners
