Cabletron Systems FN100 User Manual

Also see for FAST NETWORK 100: Quick setup guide Reference guide

Contents

Chapter 2: Unpacking and Installing the FN100Page 2-8Fast Network 100 User Guide2.6.1.1 helpUse the help command to display the menu of available commands. Helpcan also be displayed by typing a question mark (?). The output from thehelp command is displayed below.FN100 > helpFast Network 100 Command Consoleaddress [SW#] [display] [any] [ADDR [MASK]] Display learned addressesarp [display] Display the ARP tablebaud [BAUD-RATE] Display or set console baud ratebridge [PORTS [OPTIONS]] Display or set bridging methodscommunity Change the password/community namedisable [PORTS] Display or disable a set of portsenable [PORTS [noRIP]] Display or enable a set of portserase Erase configuration informationexit or logout Logouthelp [command] or ? [command] Display this menu or command usageident Display unit identificationipaddr [PORT# IPADDR [MASK]] Display or set IP addresseslocalfilter [PORTS] [hardware | software] Display or set local filteringreboot {SECONDS | off} Re-boot the unit after SECONDSroutes display [IPADDR] Display routing table informationspeed [PORTS] [auto|[man 10|100]] Display or set port speedstatus [PORTS] Display unit and port statussttimer [SW# [TIMER-VALUE]] Display or set st age timetrunk [PORTS [{on | off}]] Display or set trunking statusvswitch [SW#] [EDIT_MODE [PORTS]] Display or set virtual switchworkgroup [NAME [delete | PORTS [TYPE]]] Display or set workgroups2.6.1.2 eraseUse the erase command to erase the current FN100 configuration andreturn to factory defaults. This sets the IP address on Port 1 to 192.0.2.1(default) when the FN100 is rebooted.2.6.1.3 exitUse the exit command to log out of LCM. (The exit command isfunctionally equivalent to the logout command.)2.6.1.4 logoutUse the logout command to log out of LCM. (The logout command isfunctionally equivalent to the exit command.)