Cabletron Systems HSIM-W6 Installation Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide User guide

Contents

HSIM-W6 Installation GuideiNoticeCabletron Systems reserves the right to make changes in specifications and other information contained in this document without priornotice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.The hardware, firmware, or software described in this manual is subject to change without notice.IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, ORCONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF ORRELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEENADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES. 1998 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005All Rights ReservedPrinted in the United States of AmericaPart Number: 9032694 June 1998Cabletron Systems, LANVIEW, QuickSET, and SPECTRUM are registered trademarks, and HSIM is a trademark ofCabletron Systems, Inc.All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.FCC NoticeThis device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not causeharmful interference, and (2) this device must accept any interference received, including interference that may cause undesiredoperation.NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of theFCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in acommercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordancewith the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential areais likely to cause interference in which case the user will be required to correct the interference at his own expense.WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliancecould void the user’s authority to operate the equipment.Only qualified personnel should perform installation procedures.